The articles may be transported as in Division 1.4 Compatibility Group D (1.4D) if all of the conditions specified in 173.63(a) of this subchapter are met. Column 4 specifies the applicability of 178.275(g)(3) of this subchapter for the pressure relief devices. This molecular arrangement is exactly the same as that for dithioketo QA [5]. Note that batteries utilizing different chemistries (i.e., those battery chemistries specifically covered by another entry in the 172.101 Table) as well as dry batteries with a marked rating greater than 9-volt may not be combined with used or spent batteries in the same package. 160 This entry applies to safety devices for vehicles, vessels or aircraft, e.g. 81 Polychlorinated biphenyl items, as defined in 40 CFR 761.3, for which specification packagings are impractical, may be packaged in non-specification packagings meeting the general packaging requirements of subparts A and B of part 173 of this subchapter. TP22 Lubricants for portable tank fittings (for example, gaskets, shut-off valves, flanges) must be oxygen compatible. IBCs are only authorized if approved by the Associate Administrator. N78 Packages consisting of inner glass, earthenware, or polyethylene or other nonfragile plastic bottles or jars not over 0.5 kg (1.1 pounds) capacity each, or metal cans not over five pounds capacity each, packed in outer wooden boxes, barrels or kegs, or fiberboard boxes are authorized and need not conform to the requirements of part 178 of this subchapter. B52 Notwithstanding the provisions of 173.24b of this subchapter, non-reclosing pressure relief devices are authorized on DOT 57 portable tanks. 111 Explosive substances of Division 1.1 Compatibility Group A (1.1A) are forbidden for transportation if dry or not desensitized, unless incorporated in a device. N7 The hazard class or division number of the material must be marked on the package in accordance with 172.302 of this subchapter. 328 When lithium metal or lithium ion batteries are contained in the fuel cell system, the item must be described under this entry and the appropriate entries for Lithium metal batteries contained in equipment or Lithium ion batteries contained in equipment. Be ASME Code (U) stamped for 100% radiography of all pressure-retaining welds; b. 59 Ferrocerium, stabilized against corrosion, with a minimum iron content of 10 percent is not subject to the requirements of this subchapter. The quantities of hazardous materials do not exceed those specified in 173.4a of this subchapter; and. B83 Bottom outlets are prohibited on tank car tanks transporting sulfuric acid in concentrations over 65.25 percent. The examination and testing of each lighter design must be performed by a person authorized by the Associate Administrator under the provisions of subpart E of part 107 of this chapter, as specified in 173.308(a)(4). 21 This material must be stabilized by appropriate means (e.g., addition of chemical inhibitor, purging to remove oxygen) to prevent dangerous polymerization (see 173.21(f) of this subchapter). B7 Safety relief devices are not authorized on multi-unit tank car tanks. B133 Hydrochloric acid concentration not exceeding 38%, in Packing Group II, is authorized to be packaged in UN31H1 or UN31HH1 intermediate bulk containers when loaded in accordance with the requirements of 173.35(h) of this subchapter. 16 This description applies to smokeless powder and other solid propellants that are used as powder for small arms and have been classed as Division 1.3C, 1.4C and Division 4.1 in accordance with 173.56 of this subchapter. A rocket motor to be considered nonpropulsive must be capable of unrestrained burning and must not appreciably move in any direction when ignited by any means. Prohibited means bottom openings are prohibited, and Prohibited for liquids means bottom openings are authorized for solid material only. 164 Substances must not be transported under this entry unless approved by the Associate Administrator on the basis of the results of appropriate tests according to Part I of the UN Manual of Tests and Criteria (IBR, see 171.7 of this subchapter). (3) The total amount of gas from all detectors per outer packaging must not exceed 52 grams (1.83 ounces). 346 Nitrogen, refrigerated liquid (cryogenic liquid), UN1977 transported in accordance with the requirements for open cryogenic receptacles in 173.320 and this special provision are not subject to any other requirements of this subchapter. When the word Normal is indicated, 178.275(g)(3) of this subchapter does not apply. Heater pipes must be of welded construction designed for a test pressure of 500 psig. Column 2 specifies the minimum test pressure, in bar (1 bar = 14.5 psig), at which the periodic hydrostatic testing required by 180.605 of this subchapter must be conducted. (9) W codes. B54 Open-top, sift-proof rail cars are also authorized. 349 Mixtures of hypochlorite with an ammonium salt are forbidden for transport. TP33 The portable tank instruction assigned for this substance applies for granular and powdered solids and for solids which are filled and discharged at temperatures above their melting point which are cooled and transported as a solid mass. c. Packagings are excepted from the design stress limits at elevated temperatures, as described in Section VIII of the ASME Code (IBR, see 171.7 of this subchapter). e. When offered for transport in an ammonia dispenser, the receptacles shall be connected to the dispenser in such a way that the assembly is guaranteed to have the same strength as a single receptacle. B44 All parts of valves and safety relief devices in contact with lading must be of a material which will not cause formation of acetylides. A34 Aerosols containing a corrosive liquid in Packing Group II charged with a gas are not permitted for transportation by aircraft. Column 5 references applicable requirements for bottom openings in part 178 of this subchapter. TP9 A hazardous material assigned to special provision TP9 in Column (7) of the 172.101 Table may only be transported in a portable tank if approved by the Associate Administrator. Size of marking on bulk package must conform to 172.302(b) of this subchapter. Unless otherwise provided in this subchapter, these special provisions do not apply to UN, IM Specification portable tanks or IBCs. (3) A flammable gas is a gas that meets the criteria in 173.115 of this subchapter. (TOY CAPS) - HANDLE CAREFULLY OR TOY CAPS - HANDLE CAREFULLY; and. Each inner packaging is contained in a sealed leak-proof intermediate packaging with sufficient absorbent material capable of containing the contents of the inner packaging; c. Intermediate packagings are securely packed in an outer packaging of a type permitted by 173.158(g) of this subchapter which meet the requirements of part 178 of this subchapter at the Packing Group I performance level; d. The maximum quantity of nitric acid in the package does not exceed 300 mL; and. 138 This entry applies to lead compounds which, when mixed in a ratio of 1:1,000 with 0.07 M (Molar concentration) hydrochloric acid and stirred for one hour at a temperature of 23 C 2 C, exhibit a solubility of more than 5%. A200 These articles must be transported as cargo and may not be carried aboard an aircraft by passengers or crewmembers in carry-on baggage, checked baggage, or on their person unless specifically authorized in 175.10. The HMT provides the basic information necessary to ship a hazardous material safely. Examples of equipment are lawnmowers, cleaning machines, or model boats and model aircraft. This is in response to your November 18, 2015 e-mail and subsequent conversations with members of my staff requesting clarification of the Hazardous Materials Regulations (HMR; 49 CFR Parts 171-180) applicable to the selection of a . (5) N codes. Used or spent dry batteries of both non-rechargeable and rechargeable designs, with a marked rating up to 9-volt that are combined in the same package and transported by highway or rail for recycling, reconditioning, or disposal are not subject to this special provision or any other requirement of the HMR. TP17 Only inorganic non-combustible materials may be used for thermal insulation of the tank. If a package contains both lithium metal batteries and lithium ion batteries packed with and contained in equipment, the package must be marked as required for both battery types. B49 Tanks equipped with interior heater coils are not authorized. f. The properties of mechanical strength mentioned in this special provision shall be tested using a prototype of a receptacle and/or dispenser filled to nominal capacity, by increasing the temperature until the specified pressures are reached. b. Gases of Division 2.3 and gases with a subsidiary risk of 5.1 must not be used as a propellant in a chemical under pressure. TP5 For a portable tank used for the transport of flammable refrigerated liquefied gases or refrigerated liquefied oxygen, the maximum rate at which the portable tank may be filled must not exceed the liquid flow capacity of the primary pressure relief system rated at a pressure not exceeding 120 percent of the portable tank's design pressure. These batteries are typically used for portable power applications. 64 The group of alkali metals includes lithium, sodium, potassium, rubidium, and caesium. When IBCs other than metal or rigid plastics IBCs are used, they must be offered for transportation in a closed freight container or a closed transport vehicle. 383 For transportation by motor vehicle, substances meeting the conditions for high viscosity flammable liquids as prescribed in 173.121(b)(1)(i), (b)(1)(ii), and (b)(1)(iv) of this subchapter, may be reassigned to Packing Group III under the following conditions: a. N8 Nitroglycerin solution in alcohol may be transported under this entry only when the solution is packed in metal cans of not more than 1 L capacity each, overpacked in a wooden box containing not more than 5 L. Metal cans must be completely surrounded with absorbent cushioning material. TP8 A portable tank having a minimum test pressure of 1.5 bar (150 kPa) may be used when the flash point of the hazardous material transported is greater than 0 C (32 F). 148 For domestic transportation, this entry directs to 173.66 for: a. 335 Mixtures of solids that are not subject to this subchapter and environmentally hazardous liquids or solids may be classified as Environmentally hazardous substances, solid, n.o.s, UN3077 and may be transported under this entry, provided there is no free liquid visible at the time the material is loaded or at the time the packaging or transport unit is closed. Primary receptacles must be further packed in non-specification bulk outer packagings such as cubic yard boxes, plastic rigid-wall bulk containers, dump trailers, and roll-off containers. 380 For transportation by private carrier in a motor carrier only, this material is not subject to the segregation requirements of 177.848(d) of this subchapter under the following conditions: a. A separate drafting site You are using an unsupported browser. A portable tank may be offered for transport after the date of expiry of the last lining inspection for a period not to exceed three months for purposes of performing the next required test or inspection, after emptying but before cleaning. Lead compounds that have a solubility of 5% or less in accordance with this special provision are not subject to the requirements of this subchapter that pertain to Marine Pollutants. (d) Used or spent battery exception. d. In addition to the training requirements prescribed in 172.700 through 172.704, each driver must be trained regarding the properties and hazards of diatomaceous earth filter material, precautions to ensure safe transport of the material, and actions to be taken in the event of an emergency during transportation, or a substantial delay in transit. TP40 The portable tank must not be transported when connected with spray application equipment. 40 Polyester resin kits consist of two components: A base material (either Class 3 or Division 4.1, Packing Group II or III) and an activator (organic peroxide), each separately packed in an inner packaging. This device must also prevent an unacceptable amount of leakage of liquid in the case of overturning. The fiber drum must to be fabricated with a three ply wall, as a minimum. The provisions of this special provision will be effective until January 2, 2023, unless we terminate them earlier or extend them beyond that date by notice of a final rule in the Federal Register. Batteries and battery-powered device(s) containing batteries must be prepared and packaged for transport in a manner to prevent: (2) Short circuits, including but not limited to the following methods: (i) Packaging each battery or each battery-powered device when practicable, in fully enclosed inner packagings made of non-conductive material; (ii) Separating or packaging batteries in a manner to prevent contact with other batteries, devices or conductive materials (e.g., metal) in the packagings; or, (iii) Ensuring exposed terminals or connectors are protected with non-conductive caps, non-conductive tape, or by other appropriate means; and. These provisions apply only to transportation by rail. will also bring you to search results. (contains magnesium, magnesium nitrides) in PG II or III may be packaged in sift-proof bulk packagings that prevent liquid from reaching the hazardous material with sufficient venting to preclude dangerous accumulation of flammable, corrosive or toxic gaseous emissions such as methane, hydrogen and ammonia. N87 The use of copper valves on UN pressure receptacles is prohibited. You can learn more about the process For transportation by aircraft, as an inner packaging of a combination packaging with a maximum gross mass of 30 kg when packaged as a limited quantity in accordance with 173.27(f). (eg: In addition, for solid materials, special provision B54 applies. 340 This entry applies only to the vessel transportation of nickel-metal hydride batteries as cargo. Lead-free Solder Figure 3: Engineer soldering a microcircuit Note, Tin here is the primary metal. The requirements of 173.24(g)(1) and 173.27(c) do not apply. Specification 110A500W tanks must be stainless steel. If the air bag inflator unit satisfactorily passes the series 6(c) test, it is not necessary to repeat the test on the air bag module. Equipment powered by lithium metal batteries or lithium ion batteries must be described using the entries Lithium metal batteries contained in equipment or Lithium metal batteries packed with equipment or Lithium ion batteries contained in equipment or Lithium ion batteries packed with equipment, as appropriate. B65 Tank cars constructed before March 16, 2009, must have a test pressure of 34.47 Bar (500 psig) or greater and conform to Class 105A. B136 Non-specification closed bulk bins are authorized. 140 This material is regulated only when it meets the defining criteria for a hazardous substance or a marine pollutant. 342 Glass inner packagings (such as ampoules or capsules) intended only for use in sterilization devices, when containing less than 30 mL of ethylene oxide per inner packaging with not more than 300 mL per outer packaging, may be transported in accordance with 173.4a of this subchapter, irrespective of the restriction of 173.4a(b) and the indication of forbidden in columns (9A) and (9B) of the 172.101 table provided that: a. However, the design stress limits may not exceed 25 percent of the stress for 0 temper at the maximum design temperature of the cargo tank, as specified in the Aluminum Association's Aluminum Standards and Data (IBR, see 171.7 of this subchapter).
Cutting Horse Sales 2022,
Articles C